If you’re setting your amplifier gain by using test tones, you watch out for a buzzing sound.Ī test tone refers to a single note what plays at a specific frequency. In the tuning options mentioned above, you either watch out for distortions or square-shaped waves on an oscillator. Setting Amplifier Gain with Standard Test Tones The bass boost is also a gain setting that specifically finetunes the small band of bass frequencies. Avoid fumbling with a bass boost early.Įven though you paid for everything, including the bass, not properly adjusting the gain, while using the bass boost can unnecessarily stress out your amplifiers. A gain is designed to match the input on an amplifier with the output of the head unit. Always make sure to set your gain correctly.Ĭorrectly setting your gain is a must to avoid clipping. Look for an amplifier that has 80 – 150% subwoofer rated RMS power. When selecting an amplifier, choose one with a capacity to give your subwoofers the maximum clean watt possible. Here are what experts recommend to avoid clipped audio signals: 1. This can help you avoid blowing up your subwoofers. Using tuning tools accurately identifies sound clipping. The audio signal is rounded out at the top and the bottom waves, even when you intensify the sound.Īudio clipping or signal clipping happens when the sound waves begin to display or taper off in square-shaped bottom and top peaks. A clean, smooth sound or audio signal has a smooth curve when detected by an oscilloscope.
0 Comments
Leave a Reply. |